Spiderbox installation, for Newbies
This is a small guide to get your spiderbox working.
it might not be complete,and if theres anything that you feel needs,
to be added or is missleading please make a post here … in general discussion.
theres 3 keys you might find handy in future so write them down on a piece of paper or save it somewhere else, but we are coming to that.
1.on the backside of your stb under the power switch, and in some cases also on carton wich it arrived in, you find the ser nr it starts with an I or 1. ´write it down on paper.´
2.if you use a motor and not a fixed dish.go to your nearest referance sat,before you dissconect your old stb,
this is probably not needed if you use usals,cause then you insert your latlongitud. but to be on the safe side.
thats is what i did.
3.connect your new Spiderbox with cables such as scart-hdmi+ypbpr lnb and networkcable etc:
4.Start it up, then press menu and go to optioncontrolpanel press Ok do your settings such as hd type-video output etc: press Exit when done, and stb autosaves.
while in option choose your osd setup and time setting.
5.press Left arrow on remote to installation.
Pin code is 0000
do your preferd settings such as motordiseqc switch etc:
in motor settings press Green button on remote to set your longlatitud,
dont forgett to pess Ok on save.
now you can search for sats…. if you not use a channellist offcourse.
6.press Right arrow on remote to Accessory
go to network and press 1111
to get hidden menu… (IF THE HIDDEN MENU IS NOT SHOWN) then you first have to (LOAD A PATCH WITH GIFT) on it.
look belov how to load new patch after,,,,,(Finished. )
in network press Right arrow on remote Type to On.
do your ip setup (in most cases auto is ok) ´write down your mac address´
on same paper as ser nr and press Exit.
go down to nuevoxstream press Ok then Type to On.
go down to Authorization press Ok.
´write down key´ on same paper as ser nr and mac address and save it somewhere safe. this is the 3 keys you might find usefull in future.
now go down to register and press Ok.
now you can put in your new patchessoftcamfileschannellists.
download extract, to a fat32 formatted usb stick.
conect usb stick to spiderbox usb and in menu go to usb and find the extracted file press Ok on it.
WHEN UPDATE TO NEW PATCH CHOOSE SW UPDATE ONLY (if you choose Sw+all data your settings dissapear)
when in use of softcamfile, set both ucas to on in key edit.
when in use of a cam and card on same providers as gift,, to avoid conflicts turn gift off..
By reddy in forum Technomate Receivers Support
Last Post: 18-07-2014, 02:13 PM
By AzBox in forum CCcam Support
Last Post: 25-12-2013, 11:36 PM
By Hotzenwalder in forum Smart Cards & CardShare General
Last Post: 02-05-2013, 11:46 PM
By Guide in forum DreamBox Receivers Support
Last Post: 27-04-2013, 09:07 PM
By Guide in forum Others Digital Receivers Support
Last Post: 19-04-2013, 10:20 PM
Tags for this Thread
All posts written express the point of view of its owner, does not imply in any way the point of view of management forum.