No announcement yet.

Connect OScam and CCcam using newcamd protocol

  • Filter
  • Time
  • Show
Clear All
new posts

  • Connect OScam and CCcam using newcamd protocol

    hi all members allo cccam

    You will have to edit or create three files: oscam.conf, oscam.user and CCcam.cfg!


    Key = 0102030405060708091011121314
    Port = 34000@0b00:000000 #this is example for MTV Unlimited or any other Conax card that have 0b00 caid!


    User = test
    Pwd = test2
    Group = x #same as in oscam.server file
    AU = *** #same as in oscam.server file


    N: 34000 test test2 01 02 03 04 05 06 07 08 09 10 11 12 13 14 256

    First number is IP address of your OScam server. is used when you have CCcam and OScam on same server or receiver. If you have OScam installed somewhere else, then use regular IP (192.168.1.x). Then there is port number (34000) and username(test)/password(test2).

    At the end there are a bunch of strange numbers (01 02 03 04 05 06 07 08 09 10 11 12 13 14). They are always the same, do not change them!! You can also optionally add 256 at the end of N line. This means that your card will show as local card in CCcam. This trick is quite popular these days because many cards can be read in OScam only!
    Newcamd Extended protocol also exists but its not supported within OScam. This protocol is better than ordinary Newcamd, because it supports more CAIDs per port. Because of this issue, ordinary Newcamd is not very user friendly!