Announcement

Collapse
No announcement yet.

how to conect cccam with oscam

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • how to conect cccam with oscam

    how to conect cccam with oscam
    plz help

  • #2
    hi sir
    so as to conect cccam with oscam you should using a protocol !!!
    This tutorial will be short.
    It is intended for people who have CCcam central server (Linux PC for example) and receivers with OScam which act as clients.
    Protocol which is used between OScam and CCcam is good old CCcam !!

    Put these lines in oscam.server:

    Code:
    [reader]
    label                         = remote
    protocol                      = cccam
    device                        = 192.168.1.119,12333  #Change these two  settings according to your setup. 12333 is port of my CCcam server. If  OScam and CCcam runs on same receiver, just use 127.0.0.1 instead of  regular 192.168.x.x IP address!
    user                          = test #You will have to create F line in CCcam.cfg with username and password that you used here!
    password                      = test***
    group                         = 1
    emmcache                      = 1,3,2
    This config is basic but you dont need additional (more advanced) settings. It works just fine! If you want faster zapping,
    then i recommend that you setup oscam.dvbapi file!

    In CCcam.cfg create this line:

    Code:
    F: test test*** 2 0 0 { 0:0:1 }



    this is easy to using !!! good luck




    ---------- Post Merged at 11:50 PM ----------

    look to see !!!

    2 0 0 means that your receiver will get your local cards (if you have them), hop 1 and hop 2 cards.
    If you have server with only hop1 cards, you can just use 1 0 0


    0 0 1 means that your receivers cannot share to other receivers.
    Thats ok, because you dont need reshare in your house. Reshare (0 0 2) is usually needed if you are sharing with clients outsite your house.

    Thats it

    Comment

    Working...
    X